Ford Mustang Mach-E Wheel Specs

Ford Mustang Mach-E in 2022 stores rim diameters of 17 in, 18 in, 19 in, 20 in, and 21 in, with widths of 6 in, 6.5 in, 7 in, 7.5 in, 8 in, 8.5 in, and 9 in. 24 configurations are listed below. These are catalog rows, not a single universal size.

The stored bolt pattern in 2022 is 5×108.

Stored offset in 2022 is 38–63 mm. Offset is the distance from the rim centerline to the mounting face. A positive value places the face toward the outside of the wheel.

The year hub record is 63.4 mm (auto_model_year.center_bore_id → rim_center_bore). Trim center bore is 63.4 mm (zdonor_wheel_size_trim.center_bore).

Wheel rows are stored for 2 years, from 2021 through 2022. This page shows the 2022 rows. Choose another year to see that year's diameters. Years are not collapsed into one size.

Offset is how far the mounting face sits from the rim centerline, in millimeters. It is not the same number as backspacing. Backspacing on this page is calculated from rim width and offset because the rim table does not store backspacing.

Positive offset moves the mounting face toward the street side, which tucks the wheel inward relative to a zero offset. Negative offset moves the face toward the brake side, which pushes the wheel outward. The stored values on this page are the catalog offsets, not a recommendation to change them.

A different bolt pattern does not mount on 5×108 studs. An adapter is a separate part that converts one pattern to another. This page can look up adapter products after you choose a target pattern. It does not decide that an adapter is safe for this vehicle.

A hub-centric ring fills the gap when the wheel's center bore is larger than the vehicle hub. The stored vehicle hub in 2022 is 63.4 mm. A ring is not required when the bores match, and a ring cannot make a smaller wheel bore fit a larger hub.

Use the vehicle hub bore of 63.4 mm and the center bore printed on the aftermarket wheel. The ring size is the wheel bore minus the hub bore. This page does not copy the hub bore into the wheel-bore field.

Adding width grows the wheel on both sides of the centerline. The offset calculator estimates how far the inner and outer lips move. That estimate does not establish brake, suspension, or fender clearance.

Lowering the offset number moves the wheel outward. Raising it moves the wheel inward. The calculator on this page uses the standard width-and-offset geometry and labels the result as a position change, not a fitment verdict.

Confirm bolt pattern, center bore, thread, offset, and load rating on the wheel you are buying. Brake clearance, suspension clearance, and body clearance are not stored in this catalog, so a matching bolt pattern is not proof the wheel fits.

Stored widths in 2022 are 6 in, 6.5 in, 7 in, 7.5 in, 8 in, 8.5 in, and 9 in. A wider wheel can be compared with the offset calculator. The catalog does not say whether a wider wheel clears the brakes or the fender.

Vehicle hub bore is the diameter of the hub that the wheel centers on, taken from the model-year rim_center_bore record. Wheel center bore is the hole in the wheel. On this page the trim center bore comes from zdonor_wheel_size_trim.center_bore. When those numbers differ, both stay visible.